wyd1014
Pridružen/-a: 22.05. 2020, 02:45
Prispevkov: 14
|
 Objavljeno:
08 Dec 2020 06:40 |
  |
Together to explore the vacuum pump unit axial clearance adjustment method, I hope to help you.
1. The axial clearance of the impeller is kept at about 2-4mm by pre adjustment to prevent the shaft from extending due to the axial force of the vacuum pump unit and the screw tightening, resulting in the friction between the impeller and the guide vane surface.
Pre adjustment method: after the deep well water pump is installed, remove the motor cover, turn the adjusting nut with a wrench, and rotate the coupling anticlockwise by hand. When the coupling and transmission shaft can rotate freely, it means that the rotating part of the water pump has been lifted by the adjusting nut, and the impeller has a gap. Use a wrench to rotate the adjusting nut (press the coupling by hand), and lower the transmission shaft. When the impeller clearance disappears, the impeller and the guide vane rub, and the coupling cannot be turned by hand. When the transmission shaft is hoisted again to make the axial clearance reach 2-4mm, the position of the adjusting nut is fixed to complete the pre adjustment.
2. After 16-20h operation, the size of each part has reached a stable state, and the final adjustment can be carried out. The adjustment method of final regulation is the same as that of pre adjustment.
Water Ring Vacuum Pump
Dry Scroll Vacuum Pump
industrial vacuum pumps,vacuum furnaces |
_________________
Heat Treatment Guide,Heat Treatment Equipment |
|
